Think I may have found 2 problems:
1. When configuring an event to respond to an MD being turned on it is never triggered
2. In the advanced editor when defining a response to an event, when I press test the whole response I have defined is deleted, and no commands are sent.
Anyone seen this or am I doing something wrong? If not I will file in Mantis.
Thanks,
Chris
Re: No 2; Actually I saw that too, I thought it might be a problem with my setup as I was changing quite a bit at the time, but it seems like it is a bug.
However, if I didn't press the test button it seemed to save Ok and was triggered successfully when the event was generated from the device I created.
You might have to monitor logs for the Turned on event you are after.
Regards
Darren