Print Page - "When you can see and hear me..." I can hear but can't see!

Title: "When you can see and hear me..." I can hear but can't see!
Post by: jondecker76 on January 31, 2008, 10:14:47 PM

I've finished installing LMCE 7.10 Beta3.

I have an ASUS M2NPV-VM motherboard with an LCD tv hooked up to the HD ports. During install, I go to the part where the lady is talking - I can hear "When you can see and here me...".
I can hear the voice, but there is no picture. I could see a picture fine during install and when I first start the core (up until I get an error that it can't set the USplash resolution), but then it goes to No Signal..

I followed one of the sticky posts above, and using the number keys to select my video port does not work.

Any ideas?

Title: Re: "When you can see and hear me..." I can hear but can't see!
Post by: jondecker76 on January 31, 2008, 10:59:51 PM

Also, does it matter if I had Internet connection when I installed LMCE (I.e. did it need it to update NVidia drivers or something?)? Mine is not working as I'm currently waiting for a new DSL modem (mine is stuck in bridge mode and I can't get PPPOE to turn back on)

Title: Re: "When you can see and hear me..." I can hear but can't see!
Post by: Spyke on March 15, 2008, 07:21:51 PM

I am in the same situation except mine is plugged into a VGA monitor and as much as I love this lass' soothing voice, it would be nice to see something :)

Linux n00b
dual boot XP MCE / Kubuntu 7.10 (hopefully Linux MCE soon!)
Athlon 3200+
1gb
120gb IDE
Nvidia 7600GS

Title: Re: "When you can see and hear me..." I can hear but can't see!
Post by: totallymaxed on March 15, 2008, 10:12:43 PM

Quote from: jondecker76 on January 31, 2008, 10:14:47 PM
I've finished installing LMCE 7.10 Beta3.

I have an ASUS M2NPV-VM motherboard with an LCD tv hooked up to the HD ports. During install, I go to the part where the lady is talking - I can hear "When you can see and here me...".
I can hear the voice, but there is no picture. I could see a picture fine during install and when I first start the core (up until I get an error that it can't set the USplash resolution), but then it goes to No Signal..

I followed one of the sticky posts above, and using the number keys to select my video port does not work.

Any ideas?

Hmmm... I'd suggest moving to Beta4 bec because we have plenty of Core's/MD's running the nVidia 6150 graphics chip without any problems. So at a guess you need the newer nVidia drivers... you could upgrade these by hand... but there are enough changes/improvements that i would suggest an update to beta4 as being the preferred option.

LinuxMCE Forums

General => Installation issues => Topic started by: jondecker76 on January 31, 2008, 10:14:47 PM