I'm putting this here for a backup, just in case my system gets munched again.
Pete, and all the beta testers... it's basically a copy & paste into the appropriate GSD Commands... their all labelled.
Dan
Code is attached. in txt file.
NOTE**** This has been updated as of Jan 3, 2008
Anyone wanting to test this, you'll need to create a device template called PLM.
Don't forget to check Implements DCE
I created a command group called 'Insteon PLM' to add the commands:
add Ruby Internal commands.. and Discoverable Interfaces..
Device Data needs #37 (COM Port on PC) and #78 (COM Port BaudRate)
Both required,
#37 allowed to modify,
#78 Use Master Device List Defaults.
Haven't quite finished the PnP stuff..
Pete, can you document the PnP Script (I lost it) and your PnP settings?
Thanks
Dan
I found a few bugs in that last code update.
I'll be submitting new code here shortly. (Hopefully, with X10 Support)
Dan
Oh, I guess I should explain how I have the spidering working...
Once you start the code, it goes out and attemps to spider the network.
Give it a few minutes, it does a LOT of Insteon communication...
If you go into the log, and watch it, you can see when it's finished...
When it's finished, load up the web admin, go into Generic Serial Devices, and click the advanced button of the PLM
At the top, then click 'Send Command to this device'
select the command 'Report Child Devices' and send it.
All the sensed insteon devices are then reported to lmce..
dammit, I need a PLM and a lamplinc! aaaaaaa!
-Thom
Thom,
It's kinda hard to run the code without a PLM..
LOL
Bump, New Code in FIRST MESSAGE
Dan