hey,
first of all: this release is much better than the others. But i also have two problems:
1.) I have a Skystar2 for DVB-S - this card works very good. But i also need DVB-T, so i bought the Haupage WinTV Nova-T USB2 Stick. I've downloaded the correct firmware but it doesn't create a frontend?!?! Dmesg output is:
dcerouter_23319:/# dmesg |grep dvb
[ 13.479103] dvb-usb: found a 'Hauppauge Nova-T Stick' in cold state, will try to load a firmware
[ 13.531084] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-01.fw'
[ 14.162170] dvb-usb: found a 'Hauppauge Nova-T Stick' in warm state.
[ 14.162230] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[ 14.370884] dvb-usb: no frontend was attached by 'Hauppauge Nova-T Stick'
[ 14.370891] dvb-usb: Hauppauge Nova-T Stick successfully initialized and connected.
[ 14.370908] usbcore: registered new interface driver dvb_usb_dib0700
How can i create this frontend??
2. I also have a lot of EIB Devices (lights, drapes, ...). This devices are connected with the serial port. It worked great for the last 4 months (but not with LMCE, i used Pluto). When i go in the Web-Admin to Configuration->Interfaces and choose "EIB" I can't change my serial port. There is only a message "No serial port found". But why? I have a serial port - it works very fine with pluto. What can be the error?
Thanks in advance and please forgive me my bad (austria-) english. :-)
ciao
avajon
Hi!
Regarding 2nd issue: can you try run from console the: /usr/pluto/bin/UpdateAvailableSerialPorts.sh (it should run quickly). After this, reload the router and then try to see in Web-Admin if there are any changes in ports list. There is a recently detected issue with not always updating serial ports list, so maybe you has the same problem.
Regards, Kir
Hi Kir,
thanks for the advice! It worked!
So, there is only one problem that has to be solved :)
thanks
avajon
Hi Avajon,
Thanks for the feedback :) This issue will be finally fixed in 1.1 release.
Regards, Kir