Hello,
My NAS share is not being detected.... I ran: /usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 5 "X" 28 "Y" with the proper data... then I ran "/usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 49 1837", then I ran "/usr/pluto/bin/MessageSend dcerouter <device id> -1001 2 65 52 3 53 2 49 1768" The system found my NAS and it found the share, but it didnt really detect anything.... after double checking ... it just now detected the file system and free disk space, but there have been no media files detected. I'm at a loss. Thanks.
_nate
what is the IP address of the NAS? Do you have your network configured to LinuxMCE's requirements?
-Thom
Quote from: evilecho on December 23, 2011, 01:51:34 AM
Hello,
My NAS share is not being detected.... I ran: /usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 5 "X" 28 "Y" with the proper data... then I ran "/usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 49 1837", then I ran "/usr/pluto/bin/MessageSend dcerouter <device id> -1001 2 65 52 3 53 2 49 1768" The system found my NAS and it found the share, but it didnt really detect anything.... after double checking ... it just now detected the file system and free disk space, but there have been no media files detected. I'm at a loss. Thanks.
_nate
Try these instructions instead. http://wiki.linuxmce.org/index.php/Dianemo_S10.10#Detecting_Shares_when_adding_a_NAS (http://wiki.linuxmce.org/index.php/Dianemo_S10.10#Detecting_Shares_when_adding_a_NAS). I would delete the device from the system and recrete it using these instructions.
Good luck...
Thanks again,
Thom, my NAS's IP is 80.31 and works flawlessly with LMCE 1004. Klovell, I looked at the wiki.... and /etc/pluto/media_config.conf does not exists. Still open to all suggestions.
If I remember correctly, Dianemo's pnp plugin was castrated...