Hello i am trying lmce 10.04.
The installation went fine, but I have problems with EIB-eibd, I installed eibd and created a script to start it and it works correctly (I tested on a groupocketlisten and groupswrite).
I installed the package lmce-EIB-eibd to replace EIB, it is registred on the router, but the lights are not driven.
I followed all the recommendations of the various pages on the wiki and forums and at this point I think is a problem with the template.
Anyone try this?
Emanuele
I have a 1004 installation running my KNX install via eibd.
mmm you build from source the template or use the .deb package?
my problem is that using the. deb of 10.04 does not work. I had to use the 8.10 bin version.
Emanuele
hey,
how did you install eibd? My problem is, i can't start eibd. I tried it with the same command as in 8.10 (which worked) but with no luck. Is there a problem with ubuntu 10.04/eibd/RS232 interfaces?
thanks
avajon
hi, i use the command on wiki page and it work
I had the same problem (again) after a reinstall. Toke me 2 hours to figure out what was going on.
On terminal level i could control the light, but by linuxmce not.
Very important step!!!
Download http://deb.linuxmce.org/ubuntu/dists/intrepid/EIB and copy it to /usr/pluto/bin (and reload of course).
Be sure that the copy was successful. I had several times that the copy wasn't OK because eib was already running...
Hi, yes I had the same problem.
I also have another problem that I have not managed to solve.
I use a Merten room controller and to change clima mode (Comfort, Night, Standby or Frost) I can use two mode in ETS: 1-bit or 1 byte for each mode, but I can not use either with LMCE.
This is my device http://www.merten.de/download/DL_doku/P6232_581_03_3_1_GB_Web.pdf
For mode with 1 byte:
QuoteOperation mode object with 1 byte:
– "4" = Frost/heat protection
– "3" = Night economy
– "2" = Standby
– "1" = Comfort
I do something wrong or the template EIB is not compatible with my thermostat?