General > Users
MCE and PLC
mcc:
Hello,
has anybody tried to "peer" LinuxMCE with Fatek PLC in order to control hause? Is it acceptable solution or shall not be considered as a fully functional?
Best regards,
MCC
tschak909:
Write a driver.
-Thom
mcc:
I'm considering such option. I found also that MODBUS is the protocol which can be used in order to communicate with PLC. I have found that there is a driver for linux for modbus. I'm now considering few hause automation solutions and wanted to find something usefull, scalable and good value for money. KNX is quite expensive, so I was looking for any some alternative solution, which is able to work with MCE and scalable and flexible in terms of programming so called scenes.
Best regards,
MCC
bongowongo:
PLC-Bus?
mcc:
Hmm this is misunderstanding I think. You were thinking about power line carrier and i used PLC abbreviation for programmable logic controller.
Best regards,
MCC
Navigation
[0] Message Index
[#] Next page
Go to full version