trying to configure the linksys spa-3102 for pstn line use only, i did follow the http://wiki.linuxmce.org/index.php/Sipura/Linksys_spa3000_pstn_interface
But something must be changed since than.
I successfully created the trunk, inbound route and outbound route.
The problem is after using the "temporary hack" described below, the inbound route for broadvoice is not created.
Trunk contains ZAP/G0, SIP/House Line and SIP/broadvoice
Outbound Routes contains 0 House Line and 1 broadvoice
Inbound Routes contains 2122498618 / any CID , but no broadvoice entry.
Next, go to Wizard->Devices->Phone Lines (on the left pane in the LinuxMCE web admin, not in FreePBX). We are going to add a dummy line (NOTE: this is a temporary hack for now! I won't go into too many details other than saying that it will allow you to use the "Settings" link next to the listing to do some call routing on your pstn line!) Use the dropdown to select broadvoice. Once you do this, you will see a form to fill in some data. Just put whatever you want in the fields, they won't be used with this hack! After you are done, you will see it listed as a phone line - use the "settings" link next to it to do call routing depending on security mode! (Note: After creating this "dummy" phone line, go back to the FreePBX admin, and look at the Incoming Route for the broadvoice line. Look at the Custom App option at the bottom of the page. It should contain that same custom-linuxmce,102,1. If it does not, go back to the Incoming Route for the House Line, and change its custom app line to be the same as this one! From my tests, it should be the same (though the 3 digit number can change, so check this to be sure).
How could it be solved? I do not have voip service (yet), only pstn service.