Author Topic: Setup help  (Read 1914 times)

roblpm

  • Making baby steps
  • Posts: 2
    • View Profile
Setup help
« on: December 30, 2009, 11:15:31 pm »
Hi

New to this! Just installed system 710. This is primarily to control heat and light in garden office.

Config is core/hybrid with USB Z Wave dongle and a huge total of one appliance switch at the moment (ZRP210) attached to a heater.!

I have a couple of questions if anyone could point me in the right direction:

a) The appliance switch I have automatically comes up as a light. Which is fine. But it would be nice to have it in the climate section. I cant seem to figure out how to get it to come up there. ie so on/off in the office climate section would be for the heater attached to this switch.

b) I havent had much luck getting an orbiter onto my Windows Mobile 6 phone, any ideas?

And going forward:

c) If i get a tempereature sensor, can the temp be displayed on the orbiter?

d) Anyone retrofitted a 2 gang Z Wave light switch in the UK? There are some new MK ones, Astral but they are very expensive!

Cheers

Rob


roblpm

  • Making baby steps
  • Posts: 2
    • View Profile
Re: Setup help
« Reply #1 on: December 31, 2009, 10:44:29 am »
OK answered 1 myself! For some reason didnt get on too well with the scenario wizard. The got it through scenario screens themselves.