Author Topic: beta installation issues with Asus m2n68-vm(GeForce 7050pv/nForce 630a Graphic c  (Read 2570 times)

anupindi007

  • Regular Poster
  • **
  • Posts: 30
    • View Profile
LinuxMCE with alpha was working fine with out using nvidia card drivers(used vesa).  I have fresh installation done on the Asus m2n68-vm with LinuxMCE-0810 beta scripts i.e. new-installer-beta2.tar.gz Dated:03-Dec-2009 17:02 file size:12K.

pre-install-from-repo.sh, mce-install.sh, post-install.sh installation went well and after restarting the system says  "AVWizard Failed to setup X <OK>"

a. tty1 shows:
    Begins Nvidia driver installation..
    *************************
    Card detected: 00:12:0 VGA compatible controller[0300]: nvidia corportation Geforce 7050 PV/ nForce 630a [10de:053b] (rev a2)
    ...
    LinuxMCE prefers driver nvidia-glx-195
    ...
    Preferred LinuxMCE prefers driver nvidia-glx-195 already installed.
    *************************
    End Nvidia driver installation
    *************************
    LOG: == End Nvidia...

--> strucks here

b. i have copied existing(before nvidia installtion) /etc/X11/xorg.conf copied back but beta replaces the file. Problem still exist.

c. while running ./post-install.sh, observed the following:
    ..  
    End Nvidia driver installation
    *************************
    LOG: == End Nvidia driver installation
    post-installation-common.sh: line 123: restoreKdmInitScript: command not found
    removed '/etc/rc3.d/README'
    ..
    Remove softlink to start KDM
    removing any system startup
    ..
    /etc/rc6.d/K01kdm
 You must specify at least one of -c, -u, or -d
 Usage: /usr/sbin/update-initramf [OPTION]...
 -k[version] specify kernel version or 'all'
..


d: #dmesg    |grep nvidia
      nvidia: module lincese 'NVIDIA' taint kernel.
      nvidia  PCI INT A -> Link[SGRU] -> GSI 20 (level, low) -> IRQ20
      nvidia setting latency timer to 64

e: # cat /var/log/messages
     NVRM: loading NVIDIA UNIX x86 Kernel Module 195.22
     allocation failed: out of vmalloc space- use vmalloc=<size> to increase size
     NVRM: failed to map registers
     NVRM: RmInitAdapter failed! (0x..

seeking your help to resolve the issues

Thanks in advance.
« Last Edit: December 15, 2009, 06:05:51 pm by anupindi007 »

heynow

  • First post!
  • Posts: 1
    • View Profile
Try - Option "NoPowerConnectorCheck" "true" in xorg.conf - had similar issue with different card and that worked for me.

anupindi007

  • Regular Poster
  • **
  • Posts: 30
    • View Profile
Thanks for your inputs.   Time being I am not using Beta version and using alpha version only(recovered using from clonezilla disk backup).

Once again thanks for the same.
« Last Edit: December 15, 2009, 06:06:54 pm by anupindi007 »