Author Topic: Remove Camera (Read 13734 times)

archived · « **on:** September 08, 2006, 07:12:05 pm »

I installed a logitech quickcam on a MD to see if they work as the documentation claims and alas it did not. Now I cannot remove the camera entry on any of the orbiters , even though I have removed it from the admin webpage and regenerated and rebooted and reloaded still it remains.
Any one have any ideas ?

Regards
Dean

archived · « **Reply #1 on:** September 11, 2006, 10:00:59 am »

Be sure that you did full regeneration not just a quick.

archived · « **Reply #2 on:** September 11, 2006, 10:19:47 am »

Thanks for the reply

I have done this more than once , to no avail.

I have since tried to connect the logitech webcam to my core , are you aware of any extra actions i need to take to get it to work. In the admin website under device status the camera status is now run_config. What does this mean.

Regards
Dean

archived · « **Reply #3 on:** September 11, 2006, 10:45:00 am »

I have a webcam in my installation. I followed by this guide to setup it. Also, remember to install and load appropriate driver for your webcam. YOu can use a command dmesg to check if everything fine with your webcam.

News:

Author Topic: Remove Camera (Read 13734 times)