Author Topic: ZWave binary exits immediately (solved)  (Read 541 times)

Domodude

  • Guest
ZWave binary exits immediately (solved)
« on: November 14, 2009, 08:11:00 pm »
Hi,

I am using the ZWave-0710-32bit-20090605 binary for my zwave on a Dianemo system. All of a sudden, ZWave stopped working properly and when executing the binary manually, I get this:

Code: [Select]
10      11/14/09 20:07:43.964           Device: 406 starting.  Connecting to: 192.168.80.1 <0xb78f46c0>
10      11/14/09 20:07:43.966           Setting timeout for socket 3 to 20 <0xb78f46c0>
10      11/14/09 20:07:44.049           Socket::SendMessage type 5 id 37 from 406 to -1000 <0xb78f46c0>
10      11/14/09 20:07:44.088           TranslateSerialUSB  isn't serial usb <0xb78f46c0>
36      11/14/09 20:07:44.088           Initialization... <0xb78f46c0>
36      11/14/09 20:07:44.088           Open serial port  <0xb78f46c0>

What is going on here? I did not change any BIOS settings, and no devices were added since ZWave was just working.

Best regards,

Mark

EDIT: Somehow, it is now working again. Since I had no idea what was causing this strange behavior, I reset the dongle and downloaded the configuration from my Merten pushbutton once more. After that, it worked again. Oh well. Must have been user errer.
« Last Edit: November 15, 2009, 10:48:06 pm by Domodude »

hari

  • Administrator
  • LinuxMCE God
  • *****
  • Posts: 2420
    • View Profile
    • ago control
Re: ZWave binary exits immediately (solved)
« Reply #1 on: November 17, 2009, 03:41:31 pm »
from the logs it looks like you've set the serial port to some strange setting..
rock your home - http://www.agocontrol.com home automation