Author Topic: Respond to Event OK, but then it does something wrong  (Read 9277 times)

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Respond to Event OK, but then it does something wrong
« on: September 04, 2006, 02:51:13 am »
Hello, I have set up a respond to event that basicaly turns my receiver off (via USBUIRT) when I stop listening to media.
When I stop listening to media it turned off my receiver! GREAT! but a second later, it turns on again  :?

When I was programming the event I tested the IR code and the receiver turned off without turning on again.

Am I doing something wrong?

Thanks!

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Respond to Event OK, but then it does something wrong
« Reply #1 on: September 04, 2006, 03:01:42 am »
Just wanted to say I set up also a bluetooth detected event turning on my cablebox.. the same thing happens, it works but after it turns on, it then turns off...

At least with my cablebox the on and off code is the same, but with my receiver I don't know how is happening because the on and off IR codes are different.

Any ideas?
Martin

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Respond to Event OK, but then it does something wrong
« Reply #2 on: September 04, 2006, 09:58:48 am »
Not sure why it happens, but maybe you can try to locate those messages in DCERoter's log. Maybe they will give a clue who is producing them...

HTH,

regards,

Rob.