Author Topic: 0810 installation expierience  (Read 3138 times)


  • Guru
  • ****
  • Posts: 198
    • View Profile
0810 installation expierience
« on: May 18, 2009, 02:48:44 pm »
Installation of alpha 2.20 went fine for the hybrid core.
Mainboard used

Installation of USB-UIRT and Windows Remote without problem.
After setup, just changed the ip external ip and tired to boot the MD.

MD is using a P5N7A-VM with a Relatek ALC1200 Audio Chipset (works) and a RTL8211 LAN Chipset (works) (works not out of the box under 0710) and a Hiper_HMC-2K53A Case.
The build in VFD is recognize as Media Live LCD. But not working.

First setup architecture was set to AMD64. Changed it manually to i386 and after that MD boots up fine.

There are only two minor troubles (one is not related to LMCE )

the console is flooded with "unable to enumerate usb device on port 3), this seems to be a known buf in interpred. i use the case.
This one has built in Cardreader, VFD, IR, wifi which are causing these troubles, as soon as i disconnect them, the trouble is away.

second thing is, that sometimes on booting the md, it hangs with following error:

mount call failed : 13

after another reboot it is gone away, until next time.


  • Veteran
  • ***
  • Posts: 136
    • View Profile
Re: 0810 installation expierience
« Reply #1 on: May 18, 2009, 04:04:56 pm »
My experience (although I haven't had much time with it):

Install went clean from what I can tell.
Usb-uirt works again
It recognizes I have zwave when I plug my MCV stick, but it returns back that the device failed to start each time. Haven't had time to dig into it

That's all ived tested thus far