I have one PC in my setup and it's configured as a hybrid, I have two Insteon ApplianceLinc 2456S3 and have manually set them up as shown in the image below. There may be problems with my setup, and please tell me if there is, but I have done the best that I could figure out via the wiki. They both work fine with these settings but if I have to power down or reboot, the second one (#40) goes away and I have to manually enter it again. After I enter all the information I do an update and then a reload of the router and it works fine until I power cycle again. Any ideas what could be causing this?
Also I have an Insteon motion sensor, 2420M, that I would like to use to trigger one of the ApplianceLincs on for a set amount of time. Is there support for this type of setup?
I have attached my serial device log and image of Lighting Device Setup.