Hey! now it works better. Reset of the Seluxit and the Tricklestar did the trick.
Added the dimmers and other plug-in switches that I have.
Made a quick reload of the Core. Made function check and all works well. and abit faster response can be noticed indeed.(or it may be psychological since I know it should be)
Then I installed new switches and wanted to add those as well but now the Tricklestar behaves like that again.. (flashing red)
This never happened with the other driver so I wonder if it could be the driver or (more) possible me doing it wrong?
When adding a new switch/dimmer I simply do:
Send download config to the Seluxit
Press and hold the upper button until green, then quick press on the same button, tricklestar blinks green and I press the include combination on the switch/dimmer, tricklestar then starts to blink red.
Is this the right way(at least thats how it's done in the wiki)
Off course a reset of the tricklestar will help but then also all the config will be lost(?) and I need to go around and add all the switches again.
Not sure if I should post this in the drivers thread but instead of destroying that thread I choose to start another. It's probarbly just me doing wrong anyway?