Zwave Tricklestar procedure check

[johanr]

Hey! now it works better. Reset of the Seluxit and the Tricklestar did the trick.
 Added the dimmers and other plug-in switches that I have.
 Made a quick reload of the Core. Made function check and all works well. and abit faster response can be noticed indeed.(or it may be psychological since I know it should be)

Then I installed new switches and wanted to add those as well but now the Tricklestar behaves like that again.. (flashing red)

This never happened with the other driver so I wonder if it could be the driver or (more) possible me doing it wrong?

When adding a new switch/dimmer I simply do:
Send download config to the Seluxit
Press and hold the upper button until green, then quick press on the same button, tricklestar blinks green and I press the include combination on the switch/dimmer, tricklestar then starts to blink red.
Is this the right way(at least thats how it's done in the wiki)

Off course a reset of the tricklestar will help but then also all the config will be lost(?) and I need to go around and add all the switches again.

Not sure if I should post this in the drivers thread but instead of destroying that thread I choose to start another. It's probarbly just me doing wrong anyway?

-johan

[hari]

When adding a new switch/dimmer I simply do:
Send download config to the Seluxit

wrong!! You should never do the download config again after you have initially added the Seluxit to the Tricklestar remote. To add a new node just put the Tricklestar into config mode with the switch and then add the new nodes with the "up till flash- up" procedure. Same for device removal. The Tricklestar will notify the Seluxit about the change. This is automatically detected by LinuxMCE and you will see a popup on all orbiters with the new zwave node id.

br, Hari

[johanr]

thanks, glad thats sorted. Then I am pretty sure that is why it all of the sudden becomes angry at me
I got the feeling however that the nodes where not updated to the seluxit but I am most probarbly wrong.

Thanks again!

-johan

[Viking]

HI,

have added that info to the wiki :
http://wiki.linuxmce.org/index.php/Z-Wave#Manual_Setup_using_SIS_Mode_with_the_Tricklestar_Remote

Viking

[hari]

cool