Got myself a Denon AVR 2307 yesterday and was very impressed with the plug and play nature!!! (USB to RS232 cable)
I did notice some odd behaviour though - hoping someone may be able to assist.Prob1
I added the Off command to the AVR under the Stop Media command in "House to Sleep" scenario.
This works (turns the AVR off) but it only _stays_ off if I run the scenario when no media is playing prior to running the scenario...
If I have audio or video playing and run the scenario - the media and amp get turned off, but then about 10sec later the amp comes back on again (not the media)....I tried adding a delay of ten seconds between the stop media and off command - but other than delaying the amp from switching off - it didn't fix the problem (it still comes back on).
When no media is playing - the AVR 2307 stays off when the house to sleep scenario is run.Prob2
When I select new media, it starts to play immediately - but after a second or so - audio cuts out as Linuxmce seems to reset the Denons outputs. Then starts playing again. This doesn't happen if I change songs in a playlist - but if I load a new playlist or new media it happens every time...
Both problems are pretty minor but annoying no-the-less. Any ideas?