Author Topic: Hauppauge WinTV-Go installation  (Read 1083 times)

itsmeok

  • Veteran
  • ***
  • Posts: 100
    • View Profile
Hauppauge WinTV-Go installation
« on: January 21, 2009, 07:49:57 pm »
Hi, I found an TV capturing card in one of my old computers. I added it to my LinuxMCE system . I think linux has recognized it. On the card there was a sticker with WinTV-Go and it has a BT848 chip. I run the setup wizard in the orbiter. In the Media wizard it does not show this card as input. I found some information on the wiki but not if I have to do something before this card should be detected. Can someone tell me what steps I need to take or point me to the right wiki page ?

Result out off the lspci -v | less command
00:0e.0 Multimedia video controller: Brooktree Corporation Bt848 Video Capture (rev 12)
        Flags: bus master, medium devsel, latency 32, IRQ 18
        Memory at e6800000 (32-bit, prefetchable) [size=4K]

I hope I have the right Hauppage type as there is nothing more on the card as the above and I do not have a box anymore.

tkmedia

  • wants to work for LinuxMCE
  • **
  • Posts: 937
    • View Profile
    • LMCECompatible
Re: Hauppauge WinTV-Go installation
« Reply #1 on: January 21, 2009, 08:26:54 pm »
You most likely need to setup card in mythtvsetup.



My Setup http://wiki.linuxmce.org/index.php/User:Tkmedia

For LinuxMce compatible  systems and accessories
http://lmcecompatible.com/