Hi again.. Not sure I follow. Are you giving me a hint or just joking?
Neither, he is asking you a question, and probably laughing at one of his own suggestions for a possible answer.
Ah, Ok was unsure due to the lol thingy =). Well I will have a look at the panasonic device template, Thanks!
Offcourse I will post it in the wiki if I ever succeeds. Would be nice to finally contribute with something.
Made a Telnet to the box via reflection and the port defined in the receiver to be used for ISCP ..
The command looks like this when the reciever sends it to me(volume change)
I tried sending this( and other combinations) but never get a response(receiver doesn't react on it either)
!1PWR01 Then I make a [CR] by hitting the enter key after writing the command.
Spec:s says that the command should be like :
Guess I have to dig abit deeper into this. Wonder if the telnet can have anything to do with this?
This is really not my area of expertise but I will do a wireshark and see how it looks.
Not sure how to send a command otherwise than making a telnet to it. Will definetly have a look at the pana template..