I have a Panasonic IP Camera that was working fine. I recently reinstalled LMCE 710. After re-installation, LMCE recognized the camera.
- It created a device under 'Surveillance Cameras'
- It created a device (with the same id) under Generic Serial Devices
I reloaded router and regenerated screens. New camera appears under UI2 on the MD.
However, any time I try to view the camera,
- All the buttons appear but there is no image on the MD
- After a few seconds, DCE router is reloaded automagically
I viewed the error log and I found the following lines within xx_Generic_Serical_Device.log that corresponds to the camera.
For obscure reasons could not handle the message <0xb5885b90>
Receive string failed in HandleRequestSocket 18:ReceiveData failed Command_Impl1 Dev #47 <0xb6086b90>
I have tried it several times, and the results are the same. Sometimes, I got the following error message when the device status is '**RUN_GET_IR**'
Connect() failed, Error Code 111
Any idea what is broken here ?