Author Topic: Install bombs right after MySQL import  (Read 3867 times)

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Install bombs right after MySQL import
« on: January 29, 2006, 04:43:39 am »
Hey,

I'm trying to install Pluto onto this spare P3 computer I have, and right after it gets done importing a bunch of tables and stuff (which takes quite a while), it tries to do something else with the MySQL server and just goes downhill from that point with a ton of MySQL connect errors. It does finish the install and reboot, but comes to the menu and says something about not being able to remove a file (I was typing it when the screen refreshed and it vanished).

When I have it pull up the last few entries in pluto.log, it says that the installation was not successful and that the startup scripts are disabled. To enable, complete the installation process or remote the .notdone file.

Any ideas? I've tried burning another CD, using another hard drive, installing four times over...no luck.

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Install bombs right after MySQL import
« Reply #1 on: January 29, 2006, 10:13:58 am »
take a look at http://plutohome.com/support/phpbb2/viewtopic.php?t=563

i think your swap area is to smal!
so wen mysql is doing import i ran out off memmory

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Install bombs right after MySQL import
« Reply #2 on: January 30, 2006, 09:01:22 am »
I'll be working on this swap-too-small issue so you get a minimum 512 MB swap partition by default with the next release, instead of the current 64. For now though, you'll have to make the change manually.