Just an update guys, I got the thermostat installed over the weekend and it works well manually. However there are different zwave control setting types and you have to be mindful when pairing this device. Basically there are three ways you can control this thermostat, Full Control (you guessed it you can control all features such as heat/cool/ tempup/dwn etc), Partial control (uses standard lighting dimmer commands to just raise and lower target temp), and on/off control (just allows you to turn it on/off). Now the first time I bound the thermostat I accidentally was on the wrong type of control and LMCE recognized the thermostat as a light control. I had to re-bind and now it is recognized properly as a thermostat. I only had a small amount of time to play with it but I immediately noticed that the buttons on orbiter are not working properly with this thermostat. Heat/Cool buttons seem to be fine, but all the rest seem to send the wrong command or dont do anything to the thermostat at all. So I will dig into the template and see what I can find out.