1st test setup RAID 5 worked fine.
2nd test setup RAID 0 worked fine.
Decided to do a new full fresh install due to lots of issues and now, going through the webadmin and setting up RAID 0, it doesn't see the drives so I can't add them.
The system does see all 4 hard drives as it keep popping up and asking me if I want to use them, one at a time, but they are NOT seen in the webadmin like they were in the previous 2 installs referenced above.
Yes, it's the same 4 hard drives, freshly formatted.
Quirky or what.
So why does the main system see the 4 drives and want to use them, but the webadmin configuration RAID NOT see the drives anymore ?
Another question whilst I'm here. From the mythtv installation suggestions, it advises to use XFS or JFS as the filesystem as they are better for fast deletes (think TV recordings). I don't see any filesystem setting in the webadmin-configuration-RAID unless it picks up the current filesystem settings when it formats the RAID. Or just does it do a default ext3 ?