I have a problem that seems to be quite strange - regarding to me.
I have used MythTV for some time now - and have tried out PLuto for some time -. but having a huge problem with a mediaDirector. Normally there's haven't been any problems with the devices in my house.
I have installed the LinuxMCE DVD install on my Coreserver:
Dell Optiplex620 - With a hyperthread CPU P4.
My MD: Shuttle XPC with AMD +4600 CPU.
This is working just fine, and setting up the different parts in that machine.
But the next problem is the one, that's beeing bugging me for a week now.
I have a Shuttle XPC which I will need for my MD in my livingroom. THis shuttle is connected to my TV with VGA.
THe adding MD part works like a charm,.
But after booting the MD the first time - I can see the bootmessager - untill it goes into a mode where is should display the onscreen-Orbitor, but then it goes into blank screen - unable to show the screen (out of area) - From where I look at it - the MD works fine - but not having the rigth settings for the screeen. I have changed the resolution on the bootimage - rebuild the image etc - but ending up the same place each time.
So if someone could tell me if I'm doing something wrong during the setup??? Caurse don't know why it goes into this displaymode.
After getting the CORE up and running - I go intyo Admin interface and adding the MD - by pressing setup DisklessMD. wait for it to finish. Reload the Core and boots on the MD. Should I on that time have added the TV
Or could you do it as a part of the process.
Well - if someone could tell me what to do exactly - so I don't do anything wrong from the start, opoint after point - I'll be glad - caurse my belief is that some I do is wrong since I don't get the rigth result ?? Since it each time goes into that mode - I must be doing something wrong or the onscreen orbitor for the MD isn't registered. Or the mistake is not adding the TV ??
Please advice on how to do this correctly!