Author Topic: Reconfiguration network interfaces  (Read 2804 times)

nite_man

  • NEEDS to work for LinuxMCE
  • ***
  • Posts: 1019
  • Want to work with LinuxMCE
    • View Profile
    • Smart Home Blog
Reconfiguration network interfaces
« on: October 02, 2007, 06:39:43 pm »
Hi,

I installed LinuxMCE with one network card. Now I'm going to add another one Ethernet interface. Is there some easy way to reset a current network configuration and re-configure it?

Thanks in advance.
Michael Stepanov,
My setup: http://wiki.linuxmce.org/index.php/User:Nite_man#New_setup
Russian LinuxMCE community: http://linuxmce.ru

Zaerc

  • Alumni
  • LinuxMCE God
  • *
  • Posts: 2256
  • Department of Redundancy Department.
    • View Profile
Re: Reconfiguration network interfaces
« Reply #1 on: October 02, 2007, 09:26:17 pm »
You need to make a couple of changes in different places.  There is a thread on this forum about it, searching for eth0:0 should find it.
"Change is inevitable. Progress is optional."
-- Anonymous


nite_man

  • NEEDS to work for LinuxMCE
  • ***
  • Posts: 1019
  • Want to work with LinuxMCE
    • View Profile
    • Smart Home Blog
Re: Reconfiguration network interfaces
« Reply #2 on: October 03, 2007, 09:45:19 am »
You need to make a couple of changes in different places.  There is a thread on this forum about it, searching for eth0:0 should find it.

Thanks, I found solution - http://forum.linuxmce.org/index.php?topic=243.msg1022#msg1022. It works!
Michael Stepanov,
My setup: http://wiki.linuxmce.org/index.php/User:Nite_man#New_setup
Russian LinuxMCE community: http://linuxmce.ru