dvd failed

[teedge77]

screwed up your vista partition?  you do realize that it says right in the wiki that its going to use your entire drive right?

1. The Quick Install DVD installs both Kubuntu and LinuxMCE at the same time in 20 minutes with only 3 keystrokes. You pick the hard drive you want it to install onto, and it will partition it, format it, install everything with default options, and set your location and regional settings using an IP2Location service. The DVD installer essentially takes a pre-installed image and copies it to the hard drive. This is why it is so fast and easy. But you also don't have low-level control over the installation process. Note: this installer will erase all existing data from the selected hard drive. The DVD Installation page contains a walkthrough of this installer.

did you check to see if the hardware in your sony laptop is even supported? oh man...this is another good one.

[linuxnoob]

i think im going to try the dvd first then if that fails to the cds

[linuxnoob]

okay it installed well sort of. When it rebooted it said saided failed or some like that. To the cds i go. So i need Kubanto and the two cds right

[Hagen]

Kubuntu 0704 and LMCE CDs 1 and 2 (the two LMCE CDs are in one download if you use the torrent)

[linuxnoob]

When it said,"eeroe operarting system failed" i thought it was the dvd but kubant did it too. So im going to      swap my 30gb to 20gb and see what happens

[linuxnoob]

i installed kubuntu successfully. But its on a 8.5 gb. Will kubuntu and linux mce fit on 8.5 gb? with 80 gb for storage on other drive.

[Space]

Had this problem, re-downloaded from pirate bay bit torrent, re-burnt on different DVD and no corruption errors on install - just black screen on first boot from hard drive (i.e no graphics from my nvidea 7600).

[Zaerc]

Had this problem, re-downloaded from pirate bay bit torrent, re-burnt on different DVD and no corruption errors on install - just black screen on first boot from hard drive (i.e no graphics from my nvidea 7600).

Try pressing 1-5 and/or connecting screens to the other outputs, see also: http://wiki.linuxmce.org/index.php/AVWizard#What_to_do_if_A.2FV_Wizard_does_not_start