Author Topic: Problem using Asterisk  (Read 724 times)

teedge77

  • Addicted
  • *
  • Posts: 591
    • View Profile
Problem using Asterisk
« on: September 09, 2007, 04:57:49 pm »
I have recently gotten the 7970 going. I can see it as an orbiter and it is being registered in Asterisk. When i go to use the AMP flash panel it wont load. i get this error

Quote
Error loading configuration file variables.txt?aldope=41869


looking it up i found two references to pretty much the same thing.

http://www.asternic.org/archives/msg01332.html

http://www.asternic.org/archives/msg00262.html


i havent been able to find the op_server.pl or op_server.cfg files.

has anyone else had this trouble or any idea where these files would be....it also says that in the .cfg files /var/www/html/panel/html should be referenced. i dont even see an html directory inside /var/www. could asterisk have not installed correctly or could these have been changed? thanks for any help anyone can give.
« Last Edit: September 09, 2007, 07:10:12 pm by teedge77 »
AMD Athlon 64 X2 6000+
Asus M2V Via AM2 ATX
Lite-On LH-20A1S SATA DVD Burner
80GB  SATA-150
EVGA GeForce 7300 GT 512MB DDR2 PCI Express
Sound Blaster Audigy SE
Kingston 2 GB PC6400 DDR2 800MHz
Ultra X-Finity 800-Watt
ZCU000
Cisco 7970
TDM400P

teedge77

  • Addicted
  • *
  • Posts: 591
    • View Profile
Re: Problem using Asterisk
« Reply #1 on: September 09, 2007, 08:32:12 pm »
well....found em....now just gotta figure out editing them....


/var/www/pluto-admin/amp/panel/op_server.pl
/var/www/pluto-admin/amp/panel/op_server.cfg
AMD Athlon 64 X2 6000+
Asus M2V Via AM2 ATX
Lite-On LH-20A1S SATA DVD Burner
80GB  SATA-150
EVGA GeForce 7300 GT 512MB DDR2 PCI Express
Sound Blaster Audigy SE
Kingston 2 GB PC6400 DDR2 800MHz
Ultra X-Finity 800-Watt
ZCU000
Cisco 7970
TDM400P

teedge77

  • Addicted
  • *
  • Posts: 591
    • View Profile
Re: Problem using Asterisk
« Reply #2 on: September 09, 2007, 08:46:04 pm »
ok....it turns out the op_server.pl wasnt run first. is there a way to set this to run at boot or should it be set already and i need to change something?
AMD Athlon 64 X2 6000+
Asus M2V Via AM2 ATX
Lite-On LH-20A1S SATA DVD Burner
80GB  SATA-150
EVGA GeForce 7300 GT 512MB DDR2 PCI Express
Sound Blaster Audigy SE
Kingston 2 GB PC6400 DDR2 800MHz
Ultra X-Finity 800-Watt
ZCU000
Cisco 7970
TDM400P