first of all: this release is much better than the others. But i also have two problems:
1.) I have a Skystar2 for DVB-S - this card works very good. But i also need DVB-T, so i bought the Haupage WinTV Nova-T USB2 Stick. I've downloaded the correct firmware but it doesn't create a frontend?!?! Dmesg output is:
dcerouter_23319:/# dmesg |grep dvb
[ 13.479103] dvb-usb: found a 'Hauppauge Nova-T Stick' in cold state, will try to load a firmware
[ 13.531084] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-01.fw'
[ 14.162170] dvb-usb: found a 'Hauppauge Nova-T Stick' in warm state.
[ 14.162230] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[ 14.370884] dvb-usb: no frontend was attached by 'Hauppauge Nova-T Stick'
[ 14.370891] dvb-usb: Hauppauge Nova-T Stick successfully initialized and connected.
[ 14.370908] usbcore: registered new interface driver dvb_usb_dib0700
How can i create this frontend??
2. I also have a lot of EIB Devices (lights, drapes, ...). This devices are connected with the serial port. It worked great for the last 4 months (but not with LMCE, i used Pluto). When i go in the Web-Admin to Configuration->Interfaces and choose "EIB" I can't change my serial port. There is only a message "No serial port found". But why? I have a serial port - it works very fine with pluto. What can be the error?
Thanks in advance and please forgive me my bad (austria-) english. :-)