General > Users
How do I change network card id's?
joesixpack:
OK, I hope someone can make sense of my question. I installed LMCE and set it up to use eth0 & eth1. eth0 did not want to be a team player so I installed another card which is now eth2. I used udev to rename eth2 to eth0 but that aint working. The admin page doesn't allow you to add network cards to the settings that I can tell.
Is there any way to re-run the network portion of the setup only, to configure the changes or do I have to re-install???
Peace out
pixelator:
can you post the contents of your /etc/network/interfaces file?
joesixpack:
OK....my bad.......typo on the udev command. Dohhh!
It's working now.
tirili:
can you please post how you did this with udev.
joesixpack:
Here's a link http://www.debianhelp.co.uk/udev.htm
Navigation
[0] Message Index
[#] Next page
Go to full version