Author Topic: Z-wave USB  (Read 4329 times)

teedge77

  • Addicted
  • *
  • Posts: 591
    • View Profile
Z-wave USB
« on: June 02, 2007, 12:15:28 am »
Has anyone gotten Intermatic's HA22 USB z-wave controller to work? I am in american and that is the only one i can seem to find.
AMD Athlon 64 X2 6000+
Asus M2V Via AM2 ATX
Lite-On LH-20A1S SATA DVD Burner
80GB  SATA-150
EVGA GeForce 7300 GT 512MB DDR2 PCI Express
Sound Blaster Audigy SE
Kingston 2 GB PC6400 DDR2 800MHz
Ultra X-Finity 800-Watt
ZCU000
Cisco 7970
TDM400P

norcal

  • Regular Poster
  • **
  • Posts: 38
    • View Profile
Re: Z-wave USB
« Reply #1 on: June 02, 2007, 12:20:49 am »
Browsing the Pluto forums shows that the intermatic is not recognized, i would assume that you would run into the same issues with linuxmce. It seems that the most reliable (and confirmed working) usb z wave device is the homepro ZCU000. Unfortunately it has been discontinued but a new version has been scheduled for release some time this year. I for one will wait for the new homepro.

pixelator

  • Veteran
  • ***
  • Posts: 70
    • View Profile
Re: Z-wave USB
« Reply #2 on: June 02, 2007, 10:02:34 pm »
unfortunately, for now, your most likely support will be from the Serial version of the ZCU000. The Serial version is the ZCS000. In fact, the usb version is nothing more than the serial version with an onboard serial-to-usb conversion.

Hugolp

  • Veteran
  • ***
  • Posts: 72
    • View Profile
Re: Z-wave USB
« Reply #3 on: June 02, 2007, 10:19:29 pm »
pixelator so you are saying that the ZCS000 has suport and works under linux and linuxmce? I dont really care about serial or usb.

Hugo

PS: If someone knows where I can get a z-wave controller in spain or at least in europe I will be thankful.

pixelator

  • Veteran
  • ***
  • Posts: 70
    • View Profile
Re: Z-wave USB
« Reply #4 on: June 02, 2007, 11:52:42 pm »
@Hugolp:

LinuxMCE is a direct branch (afaik) of plutohome and the support for the serial adapter is in plutohome. So I am assuming that the support is also in linuxMCE. However, I cannot confirm that it works under LinuxMCE.