Author Topic: Linuxmce as a secondary Z-Wave controller  (Read 447 times)


  • Regular Poster
  • **
  • Posts: 41
    • View Profile
Linuxmce as a secondary Z-Wave controller
« on: August 08, 2017, 08:29:44 am »
Hi all,
I am attempting to configure my core as a secondary controller to my Vera 3 z-wave controller. Currently my Vera 3 system is stable and functional and currently consists of lighting control but will shortly be a couple of door locks. My preferance is to maintain the Vera 3 as the primary for the time being given its stability, door lock compatibility, geofencing and Alexa integration.

I am using an Aeonlabs S2 usb inclusion controller in my core to bridge the controllers.

So far i have tried to initiate suc/sis mode following wiki instructions with no luck and trasferring the Vera 3 configuration to the S2 controller and initiate download with both Sarah and diretly through webadmin.

I would like to get to a similiar setup as JaseP and have followed his steps identified in several alebit older forum posts. Is there any active users who are using this same setup that could assist?



  • Guru
  • ****
  • Posts: 168
    • View Profile
Re: Linuxmce as a secondary Z-Wave controller
« Reply #1 on: August 23, 2017, 03:14:16 pm »
Also interested in this.

BR Daniel