Help with RAID

[dothedog]

Hi All,
I had a problem with my RAID array last night where a couple of my drives just disappeared. I went and unplugged and re-plugged in all the drives and now they show up. I had to do a "mdadm --create" to get the drives back in the array for some reason. In any event, the array now shows up in the web admin as "OK" with 4 drives. The problem now is that the XFS file system seems borked. I get I/O errors when I try to write to the array, but it reads fine. It appears I need to unmount the RAID array and run xfs_repair, but when I do a "umount -f /mnt/device/163" it appears that the array is still mounted. Is LinuxMCE remounting the array after a umount? If so, how do I umount it so I can run xfs_repair?

Rob

[posde]

dothedog,

mark the device disabled in web admin, and unmount it manually. It should not remount it.

LinuxMCE automatically mounts and unmounts drives it knows about.

[dothedog]

Posde,
Thanks for the response. So I went to the web admin, advanced->configuration->RAID->advanced and at the bottom of the Device Info section check "disabled", hit save. Go to a terminal do "sudo umount -f /dev/md0" run "sudo mount" and /dev/md0 is still showing as mounted. Am I doing something wrong?

Rob

[posde]

check if md0 is in fstab. If it is, remove it. After that reboot. And it /should/ stay unmounted. If it does not, and you need to run fsck I would boot with a live cd.

[dothedog]

Well, I booted into a live cd and the xfs_repair failed. Bummer. So I guess I am rebuilding from scratch.

Thanks for the help Posde!

Rob