[SOLVED] GC-100 Setup

[davegravy]

I just aquired a GC-100 and am attempting to get it setup with my wired doorbell. The gc-100 auto-detected fine, and LMCE created devices as shown in the attached.

I noted however that none of these are considered "security devices", since under Wizard/Security it still shows "no devices". I am able to add a doorbell security device (temp#1624), but am not sure if it should be:

1) as a child to one of the sensor devices, or
2) if I should delete a sensor device and replace it with a doorbell device (child to gc100) with the appropriate channel setting in the device data, or
3) something I haven't thought of.

Can anyone advise as to the correct configuration?

[davegravy]

Doorbell device created as child of the sensor device works fine.

[Armor Gnome]

Also having the same issue, please see my newer thread here