Author Topic: Closing / openning a driveway gate from remote  (Read 3563 times)

Avner

  • Veteran
  • ***
  • Posts: 76
    • View Profile
Closing / openning a driveway gate from remote
« on: September 27, 2011, 07:28:09 am »
Hello,

I'm looking to control a driveway gate through linuxMce. So far, I didn't find a gate motor that can be controlled via zwave or X10. I did find the following heavy duty zwave relay (http://www.smarthome.com/119303/Z-Wave-30A-Relay-Contactor-Module-CA3750/p.aspx) but it is marked as discontinued. Another option is to use a zwave switch to control a non-zwave heavy duty relay that controls a regular gate motor.
Also, the zwave specifications mention a range of 30 meters assuming "open air". The distance may be an issue because the straight line from the house to the gate is obstructed by shrubs.

Is anyone familiar with:
1.   Using LinuxMce to control a motor a heavier load motor (e.g. contrary to a blind motor within the  home), using zwave, X10 or other means?
2.   Controlling from a larger distance?

Regards,
Avner
Asus P5GD2-X, Intel i915P/G, Pentium 4 3.2 GHz, 2.5GB, nvidia Geforce 8800, Hauppauge WinTV-HVR-1850

DragonK

  • Guru
  • ****
  • Posts: 446
    • View Profile
Re: Closing / openning a driveway gate from remote
« Reply #1 on: September 27, 2011, 08:03:23 am »
Hi Avner,

I had a Automated gate that I controlled via an X10 unit. UM7206. Now I was able to open teh gate from inside the house via the intercom button.
As far as I understand this is a Dry contact that triggers the relay at the gate motor to open. I just connected the UM7206 to the "button" on the intercom. The gate was then under linuxmce as a 'Light switch" named "Gate". When ever i press the "Gate" the UM7206 will "click" and the gate opens. (My gate was set to close again after 30 sec, this was not done via LMCE)

The link is from a local supplier in South Africa.
http://www.ultech.co.za/content/pdf/specs/pdf/_1c7d9a303029f7e17f.pdf

Hope I make sense........

Karel

Avner

  • Veteran
  • ***
  • Posts: 76
    • View Profile
Re: Closing / openning a driveway gate from remote
« Reply #2 on: September 28, 2011, 06:00:03 am »
Thanks Karel,
This makes sense.

Avner
Asus P5GD2-X, Intel i915P/G, Pentium 4 3.2 GHz, 2.5GB, nvidia Geforce 8800, Hauppauge WinTV-HVR-1850

tschak909

  • LinuxMCE God
  • ****
  • Posts: 5549
  • DOES work for LinuxMCE.
    • View Profile
Re: Closing / openning a driveway gate from remote
« Reply #3 on: September 28, 2011, 07:19:16 am »
A garage door with contact closure connectors can be connected via a GC-100 device's relay outputs. This can then be controlled via a lighting scenario in the garage.

-Thom

DragonK

  • Guru
  • ****
  • Posts: 446
    • View Profile
Re: Closing / openning a driveway gate from remote
« Reply #4 on: September 28, 2011, 10:32:29 am »
Thom,

The GC-100-12 would be the recommended one?

Karel