I think there's a simple question, but i got stuck in this situation, using the router delay function.
The situation is that i use a CM15A X10 controller that works fine with all signals, on off and dimer, but i had created a lighting scenario in one of my MD to do:
-Switch on upstairs light
-Switch off all lights in salon
-Wait 120 seconds
-Switch off upstairs light
All is done ok, also the last off command for the upstairs light but using the DCeRouter Delay and set it to 120 seconds (In the comment for the parameter it say that the value is in Seconds) never wait directly switch off the light.
I tried the value in minutes setting it to 2, in seconds set it to 120 and in miliseconds set it to 120000, because i had read in some post and wiki that could be in all three, but never get a good result.
Thanks in advance.