you need to put the dongle's node id into the association group 1 of the everspring sensor. From the manual:
"The Door/Window Detector supports one association group with five nodes. This has the effect that when the Detector trigger, all devices associated with Detector will be operated."
so please RTFM: http://wiki.linuxmce.org/index.php/Everspring_SP103#Association
then send a "Set Association" command to the ZWave device, with the following parameters:
#239 - the node ID of your everspring sensor (can be seen in the port/channel field)
#249 - group number, this is 1 for this device
#250 - the node id of your dongle, probably 1 when you are using the crap dongle with the inclusion button
I have done inclusion and association, but how to check and where that I did association correctly? Is there a way to list which device is associated with Aeon labs dongle?
#239 - channel for motion sensor is 7 and for door sensor 8
#249 - group is 1
#250 - aeon labs controller channel is 1
UPDATE: I got both SP103 (motion sensor) and SM103 (door sensor) to work and send trigger events!
Caveat #1: Motion sensor and led light
When I first turned on SP103 motion sensor whenever it's motion sensor was tripped red led light turned on, so it was an really easy to understand visual cue that device was working. After including motion sensor to my LinuxMCE via Aeon labs ZWave stick there was no led flashing when motion sensors was being tripped so I thought that motion sensor wasn't working and wasn't sending any alarm info to lmce, but it was. I just didn't know where to look and how to check if it was working ok or not. Now I know that all I need to do is look in webadmin Security > Status
After I done inclusion and association motion sensor showed tripping (motion detected) in webadmin Security > Status page.
Caveat #2: Door sensor needs convincing
Even after I got motion sensor to work my other sensor (door sensor SM103) didn't report any activity in Security > Status page. I tried triggering tamper switch, openning and closing doors, leaving door open, etc... but no activity showed in lmce webadmin page
Only after I deleted device from lmce, excluded it from my zwave network and repeated inclusion and association process I got it to work! First difference I saw was that now door sensor isn't using channel 8 anymore but that it is now on channel 10. And now everything works. When I open the door lmce gets signal immediately that door sensor is tripped.
I'm really, really happy that I got these sensors to work and now I can finally go do some more exciting stuff with programming lmce and making my flat smarter.