I have the door sensor listed above. When adding it to the my MCV dongle and plugging the dongle back into the computer I get the setup wizard. She walks me through the setup by telling me that a generic sensor has been detected and do I want to set it up now. I click the button that takes me to the room selection. As soon as I select a room I get a next button. I click next and I am taken to the type selection window. I select door sensor and the next button appears. I select next and I get to name the device. I type in a name and no button appears to move on to finish the configuration. I end up hitting done which usually turns the door sensor into an orbiter. I delete the orbiter that is created and the sensor ends up in the security section but does not seem to be completely functional.
Another thing I have noticed, when looking at device templates and Pluto is selected as the manufacturer, you only have one device to choose from under security <environment to choose, generic sensor template number 1813. But if no manufacturer is selected there are several to choose from including a door sensor template number 1599. In the setup wizard I don't have a choice but to select the generic sensor. How would the door sensor template be selected over the generic sensor template in the setup wizard?