I've installed the most current snapshot of 8.10 and trying to set up and use X10 with a CM15A module. For now, I've loaded it in a virtual image under VirtualBox. the goal is to learn LinuxMCE and then make a permanent installation for my home.
The problem I'm seeing is in the log of the CM15A unit, there are many pages of: received <58 41 e7 ea 2f 81 61 00> unknown data <0xb61d8b90>
The unit does not turn on and off a test lamp that's setup. The unit and lamp will respond to commands from a standard X10 hand control. It will also work from AHP.
Second, more general question: After signing out of the Administration page, the control panel is usually gone and a black window is left. Is there a way to get back to the control, so far I've had to reboot the whole image.
Thanks in advance for any help!