Author Topic: Logitech Quickcam Express  (Read 1462 times)


  • Guru
  • ****
  • Posts: 315
    • View Profile
Logitech Quickcam Express
« on: October 14, 2010, 01:19:12 pm »
hi all,

i have a old Logitech QuickCam Express, lsusb tells me:
Code: [Select]
Bus 002 Device 003: ID 046d:0840 Logitech, Inc. Quickcam Express
following these wiki's:
i have been trying to get my usb cam working;
at best i get a picture where i can, very, very vaguely see a image but with a lot of green/purple distortion (big blocks).

if i go to mythtv setup, in the 'capture card setup' section i see:
Code: [Select]
Video Device: /dev/video0
Probed info: Camera [STV06xx]

in the webadmin -> motion wrapper -> Device data -> Motion Parameters,
i set these values:
Code: [Select]
#image settings
frequency 0
rotate 0
width 352
height 258
framerate 15
auto_brightness on
brightness 25
contrast 25
saturation 25
hue 25

#http control
control_localhost off
control_html_output on
control_port 8888

despeckle EedDl
lightswitch 50
minimum_motion_frames 2

noise_tune on
threshold_tune on
smart_mask_speed 5
gap 5
post_capture 30
pre_capture 15

locate on
text_double off
webcam_quality 80
webcam_maxrate 5
text_changes on
text_right %m-%d-%Y\n%T

ffmpeg_cap_new on
ffmpeg_timelapse 60
ffmpeg_timelapse_mode daily
ffmpeg_video_codec mpeg4

#snapshot config
snapshot_interval 2
snapshot_filename %Y/%m/%d/%H/minute_%M_%S
jpeg_filename %Y/%m/%d/%H/minute_%M_%S
movie_filename %Y/%m/%d/recordings/%m_%d_%Y_%H_%M_%S
timelapse_filename %Y/%m/%d/timelapse/%m-%d-%Y-timelapse

been playing around in motion wrapper and edited resolution, framerates and the suggestions according to the wiki's,
but nothing seems to get me a good picture.

anybody any idea or suggestion?

« Last Edit: October 14, 2010, 02:20:55 pm by RayBe »
When you were born, you were crying and everybody else was laughing.
Live your life so when you die, you are laughing and everybody else is crying.