Author Topic: Zwave sensor installation problem in snapshot #23165  (Read 707 times)

ccoudsi

  • Guru
  • ****
  • Posts: 244
    • View Profile
Zwave sensor installation problem in snapshot #23165
« on: July 31, 2010, 08:23:05 am »
I just found out, when installing a zwave motion sensor "ZIR000" in snapshot #23165, using Sarah, two "Generic Sensors" get created one under (Zwave=>Zwave embedded security interf) which is OK, and a second one under (Core) which is not OK, and causing after reload to get "Orbiter cannot register with the router. Please try again later", I attached a snapshot that depict what I just mentioned.

Solution:
Delete the sensor under the Core and regenerate the oribiter and reload the router, everything is ok at this point.

P.S> I installed this zWave setup many times in the past no issues found, this is the first time I see this.
Cheers |[BEER]
Charlie,

tschak909

  • LinuxMCE God
  • ****
  • Posts: 5495
  • DOES work for LinuxMCE.
    • View Profile
Re: Zwave sensor installation problem in snapshot #23165
« Reply #1 on: July 31, 2010, 08:32:59 am »
Uh oh, bit by the setup wizard bug.
 :-X :-X :-X :-X :-X :-X :-X :-X :-X

Can you please file a ticket for this, (with the tag of Duplicate Device tree gets created when motion sensors are set up in Setup Wizard)

This one has been a bit of an oddity left over since just past 0710, but nobody seems to have made a ticket for it.

We'll get this fixed. In the mean time, you'll need to delete the extra DT #1 (core) devices.

-Thom

ccoudsi

  • Guru
  • ****
  • Posts: 244
    • View Profile
Re: Zwave sensor installation problem in snapshot #23165
« Reply #2 on: July 31, 2010, 08:35:08 am »
Sure Thom I'll do it in the morning.
Did you see the other UI issue too??
Cheers |[BEER]
Charlie,

ccoudsi

  • Guru
  • ****
  • Posts: 244
    • View Profile
Re: Zwave sensor installation problem in snapshot #23165
« Reply #3 on: July 31, 2010, 05:51:18 pm »
Cheers |[BEER]
Charlie,