Author Topic: No AVWizard  (Read 3001 times)


  • Newbie
  • *
  • Posts: 4
    • View Profile
No AVWizard
« on: May 10, 2010, 01:53:48 am »
I've installed a recent snapshot (5/3/10).
The AVWizard didn't run...the installation went straight through the Sarah!
I couldn't get the AVWizard to run by holding down the shift key during boot, or from the command line in another terminal.
I could run it from a terminal window in KDE though!
A bit ugly.
Also, I didn't see the Launch Manager, just a lot of very large text showing its normal functions.

Is all this to be expected, or have I done something wrong?



  • Veteran
  • ***
  • Posts: 136
    • View Profile
Re: No AVWizard
« Reply #1 on: May 12, 2010, 02:24:58 pm »
If you want to run the AVwizard then just run the following command.
Code: [Select]



  • Regular Poster
  • **
  • Posts: 24
    • View Profile
Re: No AVWizard
« Reply #2 on: May 17, 2010, 08:54:52 pm »
I have a similar problem as Bert. I went through AVWizard OK and loads modules and end up with pointing arrow in a black screen.
Wonder what happened to Launch Manager kicking in. I am configuring my server to act as Core only. My media director (netbooting with the Core) is ending up with a Blank screen too.- may be unrealted to the problem I have with the Core.
My install is also from 5/3/10 snapshot. I just downloaded 5/11/10 snapshot (3.7Gb) and planning to give a try tonight. Perhaps I am going the wrong way about this? Any help would be appreciated.