1
Users / Re: ZCS101 RS232 Interface Dead?
« on: April 21, 2013, 12:43:08 am »
hari,
Thanks so much. That helps.
Thanks so much. That helps.
News:
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
LinuxMCE sponsor
open.home.automation
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Users / ZCS101 RS232 Interface Dead?
« on: April 20, 2013, 04:12:56 am »
I received a new ZCS101 w/RS-232 interface. I have done nothing else with it other than power it on and connect serially to a PC. I cannot get any output despite repeated attempts at differing baud rates and serial port settings. It just looks dead. My question is whether I have a bad expectation -- should I be able to enter ASCII commands? It is the case that there is typically no firmware on a fresh unit?
Pages: [1]