Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marcb

Pages: 1 [2]
16
Installation issues / Re: Newbie With install problems....
« on: April 27, 2011, 08:20:25 pm »
After waiting a while longer i get the ubuntu 10.10 moon33 tty1 login prompt, no av wizard

17
Installation issues / Re: Newbie With install problems....
« on: April 27, 2011, 08:06:32 pm »
Hi Andew

Thanks for the quick responce, the pxe boot is getting further now......this what i am getting:

(The first few letters on the left have been chopped off, but this is what I can see)

Idmapd main process (809) terminated with status 1
Idmapd respawning too fast, stopped
isk drive for /usr /pluto/orbiter is not ready yet or not present
nue to wait; or Press S to skip mounting or M for manual recovery

There is obviously more text on the screen just more of the same with the number in brackets being replaced with:
444
661
702
732
740
758
778


Then we have
Isk drive for /usr/pluto/keys is not responding..........

And

Isk drive for /usr/pluto/deb-cache is not........

gdm main process (868) killed by term signal

And then just sits there i have left it twenty minutes before rebooting and getting the same.

Any thoughts?

Thanks

Marc

18
Installation issues / Newbie With install problems....
« on: April 27, 2011, 03:00:39 pm »
Hello,

This is my first post on this forum although i have been reading for while, i purchased a dianemo nerve centre ~(NC300) which i received today.

It booted fine and was able to setup users and rooms, i then went on to try and pxe boot my zotac HD-ID11 it failed at DisklessSetup.sh i saw in another post that you sometimes need to change the architecture back to i386 in webadmin which i did as it was set to 64bit, this made no difference still fails at DisklessSetup.sh.

The other bit of existing hardware i have that i can connect straight away is my linksys spa3102, but when i try to access phone lines in webadmin it says asterisk database cannot be found, i have selected asterisk in the core settings and it's had a restart since then. Any ideas or pointers to posts would be appreciated.

I also have a gigaset a580 ip dect handset and a sharecenter which as of yet i've done nothing with.

I'm off to go and run the satellite cables to the core maybe i can get the tv working!

Thanks

Marc

Pages: 1 [2]