Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ardirtbiker

Pages: 1 ... 17 18 [19] 20 21
271
Users / Re: Bluray Ripping
« on: May 02, 2011, 01:33:39 am »
 :-X    seals lips on this subject!!!

272
Users / Re: Bluray Ripping
« on: May 01, 2011, 09:48:17 pm »
Thanks Thom.   Will ripping from MakeMKV (then transfer over the largest title) work as a solution?  I may just have to try!

Dennis

273
Users / Bluray Ripping
« on: May 01, 2011, 09:09:08 pm »
Gentlemen (and/or Ladies) ;D

I got myself a BD-ROM (its a samsung) that I got RPC-1 firmware from RPC1.org (I am assuming it is RPC-1 firmware).   When I install a bluray disk, the 'do you wish to rip' message appears and I acknowledge with yes.   Immediately the rip fails (even a regular DVD will fail after about 15 to 20 percent).   

There is little information on LMCE Bluray ripping... is there any extra software I need to load?   if so, what?

I am not even sure where disc ripping is logged to..  the disk device (51)  is here

Code: [Select]
== ATTEMPT FRESH START ==
1       05/01/11 14:02:56       /usr/pluto/bin/Spawn_Device.sh 51 (spawning-device)     13905 Dev: 51; Already Running list: 34,35,37,36,66,
== FRESH START ==
1       05/01/11 14:02:56       /usr/pluto/bin/Spawn_Device.sh 51 (spawning-device)     device: 51 ip: dcerouter cmd_line: Disk_Drive
0       05/01/11 14:02:56       51 (spawning-device)    Entering 51
========== NEW LOG SECTION ==========
1       05/01/11 14:02:57       51 (spawning-device)    Starting... 1
1       05/01/11 14:02:57       51 (spawning-device)    Found /usr/pluto/bin/Disk_Drive
01      05/01/11 14:03:02.776           FindFirstRelatedDeviceOfCategory 115 dev 52 never registered <0xb76b76c0>                                                                           
05      05/01/11 14:03:02.776           Disk_Drive_Functions::Disk_Drive_Functions warning m_pDevice_MediaIdentifier 52 isn't registered <0xb76b76c0>                                       
sambahelper@moon33:/var/log/pluto$ tail -f 51_Disk_Drive.log
== ATTEMPT FRESH START ==
1       05/01/11 14:02:56       /usr/pluto/bin/Spawn_Device.sh 51 (spawning-device)     13905 Dev: 51; Already Running list: 34,35,37,36,66,
== FRESH START ==
1       05/01/11 14:02:56       /usr/pluto/bin/Spawn_Device.sh 51 (spawning-device)     device: 51 ip: dcerouter cmd_line: Disk_Drive
0       05/01/11 14:02:56       51 (spawning-device)    Entering 51
========== NEW LOG SECTION ==========
1       05/01/11 14:02:57       51 (spawning-device)    Starting... 1
1       05/01/11 14:02:57       51 (spawning-device)    Found /usr/pluto/bin/Disk_Drive
01      05/01/11 14:03:02.776           FindFirstRelatedDeviceOfCategory 115 dev 52 never registered <0xb76b76c0>                                                                           
05      05/01/11 14:03:02.776           Disk_Drive_Functions::Disk_Drive_Functions warning m_pDevice_MediaIdentifier 52 isn't registered <0xb76b76c0>                                       
01      05/01/11 14:05:01.389           Disk_Drive::CMD_Eject_Disk  tLastEject 1304276701 (1304276701) tray open: 1 <0xb6634b90>                                                           
05      05/01/11 14:05:25.024           Disc of type 0 was detected <0xb76b76c0>
05      05/01/11 14:05:25.024           Not firing the event <0xb76b76c0>
01      05/01/11 14:05:45.653           Disk_Drive::CMD_Eject_Disk  tLastEject 1304276745 (1304276745) tray open: 1 <0xb6634b90>                                                           
05      05/01/11 14:06:10.239           Disc of type 28 was detected <0xb76b76c0>
05      05/01/11 14:06:10.239           One Media Inserted event fired (/dev/scd0) m_discid: 1304276770 <0xb76b76c0>                                                                       
05      05/01/11 14:06:14.950           Translated directory '/home/public/data/___audio___or___video___/WDC_WD15EARS-00Z (sdc1) on dce [32]' => '/home/public/data/___audio___or___video___/WDC_WD15EARS-00Z (sdc1) on dce [32]' <0xb6634b90>                                           
05      05/01/11 14:06:15.090           RipTask::UpdateProgress id 0 m_eTaskStatus_get 1 status e message  file /home/public/data/videos/WDC_WD15EARS-00Z (sdc1) on dce [32]/Unknown disk () <0xb6634b90>


but not sure what some of it means.

Can anyone give me some direction?

Thanks in advance,
Dennis

274
Installation issues / Re: newbie installation woes
« on: May 01, 2011, 02:57:17 pm »
Glad I could help... sometimes things get 'lost in translation'  here in the forums... after reading a few posts, I knew I should chip in.

Good luck.

Dennis

275
Installation issues / Re: newbie installation woes
« on: May 01, 2011, 02:18:16 pm »
I have a 2-wire DSL router as well.. it has built-in wireless, and 4 lan ports and USB port on the rear.   This device provides DHCP for a 'normal' home setup.   I have my Core connected to one of the ethernet jacks in the back...   I then have another lan card in my core that is connected to a 1Gb ethernet switch that my Media Directors are connected to.     This is the preferred setup for a LMCE home network.   Note though that I do have another PC that I use that is also connected directly to the 2-wire router.. I dont want this PC to be part of the home network because it is my 'backdoor' to the internet if i am 'tinkering' with my core PC.

Dennis

276
Users / Re: Media files do not show up under "sort by filename"
« on: April 16, 2011, 02:46:13 am »
yup...  I had the same situation... I had two internal hard drives for data.. only the drive links were shown, but if you go into the links, whatever media was on them showed up...

I guess it is a 'feature' of the 'sort by filename'  :-\

Dennis

277
Installation issues / Re: can't get in the webadmin
« on: March 26, 2011, 05:55:22 pm »
actually.. the password for my login to webadmin was same as username   im pretty sure the 1234 is the pin for access in the orbiter

Dennis

278
Developers / Re: zigbee support
« on: March 26, 2011, 05:14:53 pm »
like OMG... its the latest thing!!!!!   gotta have it    ;D

279
Users / Re: Command "Tune to Channel" use in Device Template
« on: March 26, 2011, 05:10:20 pm »
To the LMCE developers:

Trac Ticket #1039 (new feature_request) submitted today.  sqlCVS-Diff completed as well (I hope...it said it completed successfully)

Dennis

280
Developers / Re: SiriusXM
« on: March 24, 2011, 11:32:26 pm »
not bad at all!!!   and you said you were not an artist!!!

Dennis

281
Installation issues / Re: Connecting A USB DVD Drive
« on: March 21, 2011, 03:23:21 am »
I hear ya... I'll be learning for years!

I dont think i have the smarts to help with your DVD issue though.


Dennis

282
Users / Re: Command "Tune to Channel" use in Device Template
« on: March 21, 2011, 03:20:03 am »
Will do Sir!

it may not be right away as I wish to test it further.


Dennis

283
Users / Re: Command "Tune to Channel" use in Device Template
« on: March 21, 2011, 01:13:38 am »
just magic!!!!


however, this whole thing about going directly to the STB instead of using the Directv.pl script didnt resolve the issue that has been bugging me...

When I changed channel, my HDPVR would cycle while the channel changed... if I were changing from an HD channel to a SD channel, it would fault and either crash Myth or Myth would display an error and dump me to its menu.

If I changed my STB directly with the STB remote, the channel changed perfectly...   


SO...  I guess somehow Myth is not set up right, or this is a normal operation of the HDPVR during channel change.

any input?


Dennis

284
Installation issues / Re: Connecting A USB DVD Drive
« on: March 21, 2011, 12:42:23 am »
another silly question...

is your main tv connected to the core as well?   or on a diskless Media Director?

if the latter, did you also install libdvdcss2 on that as well?


Dennis

285
Installation issues / Re: Gyration Remote keys all wacky
« on: March 20, 2011, 09:40:39 pm »
Yay!    <applauses from the crowd> 


Dennis

Pages: 1 ... 17 18 [19] 20 21