Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - RayBe

Pages: 1 2 3 [4]
46
Installation issues / Canot connect to X server
« on: April 08, 2010, 05:59:47 pm »
I got a message "cannot to x server" after tryig to add a diskless MD
also it won't boot further then setting up Upnp server
i'm on LMCE 710
any ideas?

tanks Raymond

47
Installation issues / Installing Ocelot
« on: April 04, 2010, 08:21:07 pm »
Hi,
I have been using LinuxMCE for a month and been trying to get this working,
i am a complete newbie to LinuxMCE and in creating a GSD with or without Ruby.

From a friend i got this interface: http://www.appdig.com/adicon_new/ocelot.htm
with 2 of these: http://www.appdig.com/adicon_new/bobcat_serial.htm (rs232)
and 1 of these: http://www.appdig.com/adicon_new/secu16ir.htm
and a X10 module connected to the Ocelot

could someone please help me out to get the Ocelot, 3 modules (including IR) and the X10 module completly working.
Or point me in the right direction.
Where and how do i start creating GSD, have been trying a lot.
Would be great if someone helped me with a step by step detailed instruction (dummy style :) )
thanks a lot up front,

48
Users / Help getting Ocelot working
« on: April 04, 2010, 03:00:14 pm »
Hi,
I have been using LinuxMCE for a month and been trying to get this working,
i am a complete newbie to LinuxMCE and in creating a GSD with or without Ruby.

From a friend i got this interface: http://www.appdig.com/adicon_new/ocelot.htm
with 2 of these: http://www.appdig.com/adicon_new/bobcat_serial.htm (rs232)
and 1 of these: http://www.appdig.com/adicon_new/secu16ir.htm
and a X10 module connected to the Ocelot

could someone please help me out to get the Ocelot, 3 modules (including IR) and the X10 module completly working.
Or point me in the good direction.
Where and how do i start creating GSD, have been trying a lot.
thanks a lot,

Pages: 1 2 3 [4]