91
Users / Re: climate control
« on: May 17, 2011, 08:15:01 pm »
Thanks Thom. I don't suppose there is a way to duct tape it? I'm thinking I'll re-wrap my usb uirt and save it for another day, but I'm curious...
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
The Climate plugin does not inherit from the infrared code, and thus climate devices can't currently be IR controlled (unless somebody has checked in code for this at some point...)
You wouldn't want to do this anyway, IR devices are a compromise for the A/V world, and as such, you'll run into all sorts of funky quirks because IR is unidirectional and incapable of communicating back its state to the system.
-Thom
My core started out as a hybrid, but for installation purposes only. Since then, I have setup AutoStartMedia to 0, and it works just fine.
in my Home theater I have front and rear lights, now i have them both hooked up to GE Zwave dimmers
I have one dimmer at the entrance to the room and would like it if i could touch the switch and have LMCE switch the front and rear lights on dependent on time of day ETC, but for now just the basics.
I have created two events in respond to events
when device = rear lights = 1 then front lights on
when device = rear lights = 0 then front lights off
i then reload and test it out and nothing, I have a Aeon Zstick 2 and a Aeon Labs MiniMote followed the wiki on SIS/SUC
01 05/05/11 19:28:30.740 TranslateSerialUSB pci0000:00/0000:00:1d.0+1 result /dev/ttyUSB1 <0xb58c2b90>
01 05/05/11 19:30:21.134 TranslateSerialUSB pci0000:00/0000:00:1d.0+1 result /dev/ttyUSB1 <0xb588ab90>
01 05/05/11 19:33:38.002 Ruby was unable to handle the command in reasonable amount of time <0xb708db90>
01 05/05/11 19:33:56.002 Ruby was unable to handle the command in reasonable amount of time <0xb708db90>
01 05/05/11 19:34:22.003 Ruby was unable to handle the command in reasonable amount of time <0xb708db90>
01 05/05/11 19:34:40.002 Ruby was unable to handle the command in reasonable amount of time <0xb708db90>
01 05/05/11 19:34:48.322 For obscure reasons could not handle the message <0xb5089b90>
01 05/05/11 19:34:48.322 For obscure reasons could not handle the message <0xb5089b90>
01 05/05/11 19:34:48.322 For obscure reasons could not handle the message <0xb5089b90>
re Jarvis: There is a skin called Jarvis... I don't know how complete it is, but there is a skin entry for Jarvis in the system
Just don't get a GT210 Nvidia card.
Josh
If you need to reinstall the MD, bear in mind that in the past, possy has recommended that you do not delete MDs, and that instead you should change the MAC address and then the MD will be detected again as a new one. Of course this will leave unused MDs laying around in web admin, but it doesn't matter.
Can you confirm you make/model, the template you are using and post your log when this is occuring?