Messages

1

Users / mediatomb/fuppes in 8.10

« on: December 17, 2009, 09:36:56 pm »

I've been using 7.10 for a while now, and managed to get upnp streaming working no problem to my xbox 360 with fuppes. I decided to give 8.10 a go and found that fuppes has been replaced with Mediatomb, which does not support the xbox 360. Is it possible to run fuppes instead of mediatomb on 8.10 and if so how?

2

Users / Re: dhcp routing table

« on: December 13, 2009, 09:38:06 pm »

ah, jolly good, any chance that is buried somewhere nice like in the admin website?

3

Users / dhcp routing table

« on: December 13, 2009, 09:28:25 pm »

Hi all, does anyone know if there is a way to see the dhcp routing table, ie a list of all devices connected to the internal network and their ip addresses?

4

Users / Re: TV and Projector from one MD

« on: December 03, 2009, 09:07:37 pm »

Andrew, thanks for the reply, I hadn't considered using some sort of switching device, any recommendations on what brand or supplier you use?
best

J

5

Users / TV and Projector from one MD

« on: December 01, 2009, 05:28:46 pm »

Hi all, I am an LMCE noob, just setting up, and i have a question about how i might be able to have my TV and projector hooked up to the same MD and wondered if anyone knew how to solve it? My CRT TV is connected via svideo and Projector is connected via VGA from the nvidia graphics card in the MD. Is there any way of either fast switching between the outputs so i get SD on the TV and HD on the projector? Or should i clone the output of one to the other?

Or do i need an MD for each device? which would suck a bit.. but not impossible!