hi,
i've just finished my house with EIB/KNX for and I´m thinking of using LinuxMCE too. But I was thinking of using Cytech comfort for alarm system and also for some KNX operation (because I have only 1 BUS line and almost maximum of participants), i've been searching the forum but didn't find much info about usin comfort with LinuxMce.
So I ask? Can I use the comfort alarm operating some KNX needs and still use LinuxMCE?
Another Problem is my door bell? wiche equipment should I use in order to have video and audio wich I can integrate with LinuxMce?

thanks
Nelson

Hi People,

I've been trying to find out what are the supported alarm panels but couldn´t find it. Could someone point me where to find it?

Another question is what should be the best configuration for the alarm attending to the wiring I have:
- KNX based wiring for lights, shutters, heating sensors, presence sensors;
- separate wiring system for alarm, though it can be integrated if I want because all wiring goes to same place in basement;
- for KNX integration I´ll be using IP gateway from BERKER

What I'd like to know this:
- the best way to integrate alarm with linuxmce
- if it is possible to use KNX sensors to complement the intrusion alarm, and heating scenarios,

thanks
nelson