Well first off I am using the amd64 version and also linuxmce 0704, when I try to learn the codes by using the learn feature in the web admin nothing happens.  Your http://mantis.linuxmce.org/view.php?id=4075, tells me to enter a username and password.

Also I have a usb service port on the back of my tv, I was wondering if I could probably program the codes that way, if it was possible?

Well first off I am using the amd64 version and also linuxmce 0704, when I try to learn the codes by using the learn feature in the web admin nothing happens.  Your http://mantis.linuxmce.org/view.php?id=4075, tells me to enter a username and password.

Also I have a usb service port on the back of my tv, I was wondering if I could probably program the codes that way, if it was possible?

having issues getting the codes to learn via the usb uirt, I see the setup looks correct but not learning? Any suggestion or can some one point me to the right topic to help with this issue

I have an nvidia 8500 card. when i set it to ui2 or 3, it give me a transparenciy error and says cant use opengl, any suggestions on what to do ?

Thanks

Right now I am trying to upgrade the nvidia 8500 drviers, but i am having a hard time finding the file to upgrade so i can access ui2 or maybe even 3, any suggestions?

Thanks for that!

I can not find my xorg.conf file in linux cmmd prompt. could that be the issue also?

What is the linux command to get to it again?

Does anyone know which is a good nvidia card that does UI2 or UI3? I have a:

BFG GeForce 8500 GT - graphics adapter - GF 8500 GT - 512 MB

http://www.officedepot.com/a/products/468430/BFG-GeForce-8500-GT-graphics-adapter/

but for some reason will not get past UI1?

Man, I have tried all the IR codes in the world and still no luck. I used the usb service port to program my codes for my tv, and all the code set I have tried have been s*** out of luck for me any suggestions anyone?

Does any know if the Cm11a module or cm15a module with usb will work for controlling the lighting, my pc does not have a serial por interface?

Anyone know where to get some cheap thin clients, that re pxe bootable

do i need to get me a cm11a module?

so what about these switches, anyone had any experience with these:

http://kbase.x10.com/wiki/WS467

Can I use the USBUIRT to setup my  Sony Dg150 reciever, and my Mitsubish1 wd52528 or 52527 52'' television?

to be honest with you I really dont want my lighting system to dim at all just basically off and on. Jondecker I know you mentioned the XPS3 switches, what module did you use? or connect to your core/hybrid?

Hey I am trying to get some information about which lighting thingy to go with? I just got my house built and i had them place x10 switches in each room, will I have issues with this if I do the cm11a or x10, or should I go with the Zwave setup. Also which zwave model would be recommended and works?